• Twist open the chamber of the device.
• Break the seal of the serum vial, remove rubber stopper and pour serum into the chamber of the device.
• Place the lid back on the device and twist to close tight.
• Optional: You can mix two serums and fill it until it’s half full.

• Leave the device upside down for 1-2 minutes.
• During this time, wash your face and make sure your hands are clean.

• Once the serum has had enough time to make its way into the needles, you can take off the lid and start microinfusing!

• Start at the center of the face and work your way outward to cover the full face.
• Stamp with a 50% overlap. This means each time you stamp you overlap the previous stamp halfway.

• Aim to have the serum always on the end where the needles are when stamping to ensure you’re infusing serum into skin whilst stamping.
• This might require you to slightly adjust the angle of your famping whilst stamping.

• Take all the leftover serum from the device and pat it onto your face and neck.
• Leave the serum on overnight so your skin can drink up all those nourishing ingredients.

• Once treatment is done, place lid back on the device and twist off the needle head to safely dispose.
• Open and use a new sterile needle head per treatment.

If you would like more collagen-building on a specific area such as a stubborn divot or acne scar, go over that area 2-3 times to target that concern. If you have any active blemishes, you can get as close as possible, but avoid stamping directly on any active breakouts on the skin.